Discoverwhat’spossible™…www.fisher-price.comModel Number: B1637Please keep this instruction sheet for future reference, as it contains important infor
10•Position the lights ‘n sounds tray on a flat surface, with theroller facing you.•Position the mirror base, with the mirror toward you.•Fit the mirr
11Batteries may leak fluids that can cause a chemical burninjury or ruin your product. To avoid battery leakage:•Do not mix old and new batteries or b
IMPORTANT! Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges.DO NOT use if any parts are missing
Using the Tray13Adjust the seat angle in any of three positions:Upright, Semi-Recline or Recline.To adjust the seat angle:•Push down on the seat back
SwingingHint: As with most battery-powered swings, a heavier child reduces the amount of swinging motion onall settings. In most cases, the low settin
CareStorage•Fit the bottom of the remote into thecupped portion of the holder.•Push to “snap” the top of the remoteunder the holder clips.•Press the
•Make sure the remote is no further away than 20 feet fromthe swing.•Make sure the remote and the swing are in a direct line andthere are no obstacles
2Occasionally a consumer may experience a problem withone of our products. If this should happen, please call ustoll-free, rather than return this pro
Parts3Front BaseRear BaseHousing2 Rear Legs(Shorter)Motor HousingSeat with Restraint2 Seat TubesBracket(with M4 Lock Nuts)Seat Wire2 Seat WireCaps2 Ac
•Place the front base on a flat surface.•Position a front leg (longer) so that the tapered end isdownward, as shown.•While pressing the button on one
Assembly5• Position a rear leg so that the tapered end is upright.•While pressing the button on the top of the rear leg, insert itinto the housing sho
•Place the rear base on a flat surface so that the buttons face the front base.•While pressing the buttons on each side of the rear base,fit the rear
• Insert four M4 screws through the seat tubes, bracket andinto the lock nuts.Tighten the screws.Assembly•Rotate the seat tubes down.•Fit the seat wir
•While holding the seat wire in place, carefully turn the seat around so that the front of the seat faces you.•Position the seat wire cap so that the
Assembly•Fit the pocket on the back of the pad onto the seat back.•Fit the waist belts through the smaller slots in the pad.9Waist BeltsPadSlotSlot23•
Kommentare zu diesen Handbüchern