Fisher-Price L0542 Bedienungsanleitung

www.fi sher-price.co.ukL0542IMPORTANT! KEEP INSTRUCTIONS FORFUTURE REFERENCE.

10AssemblySmaller Baby• Insert the ends of the shoulder straps through the lower slots in the pad.• From behind the product, attach the ends of the sh

11Prevent serious injury or death from falls or sliding out: The child should at all times wear a safety harness correctly fitted and adjusted. The tr

124To change strap slots:• From behind the product, squeeze the restraint release tabs and remove the shoulder straps.• From the front of the high cha

13Using the Trays6Base TrayArmrest• Fit the base tray onto the seat armrests. Push down until the base tray "snaps" into place.Hint: Before

14Teether ToyTabSlotTab• Insert and “snap” the teether toy tab into either slot in the tray.Hint: To remove the teether toy, press the tab and lift

15Adjusting the Seat To adjust the seat angle:• Squeeze the seat back handle and push the seat back forward or, pull it backwards to the desired posit

• With the legs all the way open, lower the seat to position 7 the lowest position).• Pull the frame release latches forward and push the rear legs to

2Prevent serious injury or death from falls or sliding out:• The child should at all times wear a safety harness correctly fitted and adjusted. The t

3Assembled Parts 2 BasesFootrest2 FramesHinge Rod2 Seat Bottom TubesPad Seat BottomSeat BackBase TrayFood TrayTeether ToyNote: Tighten or loosen all s

41• Place the seat bottom face down on a flat surface.• At an angle, fit the footrest on the seat bottom, as shown.AssemblySeat BottomFootrest• Slide

5Assembly4• Insert two #10 x 2,2 cm black screws through the footrest and into the seat bottom. Tighten the screws. This may require extra force.Inser

67Assembly• Pull the frame leg out on each frame to open. Make sure it "clicks" into place.• Position a frame so that the decorated side is

7Assembly10Base• Insert the frame front legs onto the remaining base.• Fit a screw retainer over a hole in the front leg.• Insert a #10 x 2,2 cm black

8Assembly12• Push each seat height adjuster to be sure they are completely on the seat bottom tubes.• Insert a #8 x 1,9 cm screw through each seat hei

9Assembly16Clips• Fit the clips on the front edge of the pad onto the seat bottom.• Hook the elastic loops on each side of the pad onto the tabs in th