Fisher-price H4790 Bedienungsanleitung

1InstructionsModel Number: H4790Please read these instructions before assembly and use of this product.Adult assembly is required. Tool needed for ass

10Assembly• Fit the strap on the top of the headrest through the handle.• Fit the pad strap through the handle and press it to the smallfastener on th

1111Securing Your ChildIMPORTANT! Before each use, inspect this product for damagedhardware, loose joints, missing parts or sharp edges. DO NOT useif

1212Securing Your Child4• To tighten the shoulder belts: Hold the adjuster and pull thefront shoulder strap down.• To loosen the shoulder belts: Slide

13Prevent serious injury or death fromfalls or sliding out. The child should at alltimes wear a safety harness correctly fittedand adjusted. The tray

1411Release BarBase Tray• While pushing the release bar on the front of the base tray, pullthe tray base towards you and remove.Base Tray12• Fit the f

15Adjusting the SeatPrevent serious injury or death fromfalls or sliding out. It is recommendedthat the high chair be used in the uprightposition only

Storage16Base Tray• Fit the holes on the base tray latches onto the pegs on the backof the high chair frame.PegHole17Pull Frame Release Latch• With th

WARNINGThis product contains small parts in its unassembled state.Adult assembly is required.Prevent serious injury or death from falls or sliding out

33PartsPad3 Food Trays2 Toys (Toys may be different)Seat BackSeat BottomFrameHinge Rod2 Seat Bottom Tubes4 Screw RetainersBase TrayFrameFootrestHeadre

42• Slide a seat bottom tube through each set of plastic rings onthe seat bottom.1• Place the seat bottom face down on a flat surface.• At an angle, f

55Assembly4Insert Screws HereFootrest• Insert two #10 x 2.2 cm black screws through the footrest andinto the seat bottom. Tighten the screws.#10 x 2.2

666Assembly8• Identify the back and front base. The front base has tapered legtubes. You will use the back base for the next assembly step.Tapered Leg

777Assembly12FrontLeg HolesScrew Retainer - 2#10 x 2.2 cm Black Screw - 2• Insert the frame front legs onto the front base.• Fit a screw retainer over

888AssemblyBack and Bottom ViewSeat Bottom Tube Ends14Seat Height Adjusters• From the back and bottom of the assembly, insert a #8 x 1.9 cmscrew throu

9AssemblyShoulder Portion16• Insert the crotch belt through the slot in the pad. Make surethe crotch belt is not twisted.• Fold the top of the pad dow